Cooper-instruments-systems Series M3 Digital Force Gage Instrukcja Użytkownika Pobierz pdf (Strona 6)

Series 3 Digital Force Gauges User’s Guide

operator and others in the vicinity. If using a grip or fixture from a supplier other than Mark-10, ensure that

it is constructed of suitably rugged materials and components.

Do not use jam nuts or tools to tighten grips or attachments onto the shaft. Finger-tighten only.

4 HOME SCREEN AND CONTROLS

4.1 Home Screen

No.

Name

Description

Tension /

compression

indicator

- indicates a compression (push) direction

- indicates a tension (pull) direction

These indicators are used throughout the display and menu.

Peaks

The maximum measured compression and tension readings. These readings

are reset by pressing ZERO or by powering the gauge off and on.

Primary reading

The current displayed force reading. See Operating Modes section for

details.

Load bar

Analog indicator to help identify when an overload condition is imminent. The

bar increases either to the right or to the left from the midpoint of the graph.

Increasing to the right indicates compression load, increasing to the left

indicates tension load. If set points are enabled, triangular markers are

displayed for visual convenience. This indicator reflects the actual load, which

may not correspond to the primary reading (depends on operating mode).

The ZERO key does not reset the load bar. See Operating Modes section for

details.

Units

The current measurement unit. Abbreviations are as follows:

lbF – Pound-force

kgF – Kilogram-force

gF – Gram-force

N – Newton

Note: not all gauge capacities measure in all the above units. Refer to the

capacity / resolution table in the Specifications section for details.

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Brak uwag

Cooper-instruments-systems Series M3 Digital Force Gage Instrukcja Użytkownika Strona 6